裝卸工安全作業交底.doc

內容摘要：
1、 搬運工在搬運前必須認真學習本工種操作規程中的裝卸要求，并遵照執行，對零星裝卸也應符合安全運輸的有關規定。
2、 起重搬運各種大小設備時，必須統一規定口號、信號，統一指揮進行操作。
3、 起重搬運工具，使用前必須進行檢查，不符合安全規定的不準使用。
4、 搬運機器，必須查明重量、尺寸、裝卸地點后，才能操作。
5、 裝運各種材料、物件時嚴禁超載、超高、超長、超寬。
6、 車輛未停穩，嚴禁人在車輛上操作或上、下爬車，物件堆放要平穩。車輛行駛時，禁止人坐在欄板上或車頂高處，更不準站在物件的頂頭，防止急剎車物件往前突然移動而軋傷人，裝運構件，必須選好墊頭木、掛好緊線器，防止物件倒坍造成事故。
7、 密切配合駕駛員，車輛進出照顧前后，倒車、轉彎、領車、正常行駛時應注意前后左右馬路上的動態。
裝卸乙炔、氧氣瓶時應輕裝輕卸，嚴禁拋
Abstract:
1, porters seriously studying before the removal operation rules in handling this type of work required, and follow the implementation of the sporadic loading should also be consistent with the safe transport of the requirements.
2, lifting handling equipment of all sizes, must be unified regulations slogans, signals, unified command to operate.
3, lifting handling tools must be inspected before use, do not meet safety requirements are not allowed to use.
4, handling machines, must identify the weight, size, loading and unloading sites, to operate.
5, shipping materials, objects are forbidden to overload, high, long, wide.
6, a parked vehicle is not prohibited in vehicle operation or on the crawl under the car, piled up to a smooth object. Vehicles, the prohibition of people sitting on the tailgate or roof height, but not allowed to stand in the immediate object, to prevent the brakes suddenly forward movement of objects rolling wounding, shipping component, must choose the right pad first wood, hanging good tight line device, to prevent accidents caused by objects collapsed.
7 closely with the driver, vehicle and out of care before and after the reverse, turn, lead car, the normal running around, the roads should pay attention to the dynamics.
Handling acetylene, oxygen cylinders should care, and non-throwing
 

前往下載