南沙經濟開發區蕉前路A2標鋼筋安全技術交底卡.doc
進入下載頁
安全交底內容:
1、 用機械對鋼筋進行切斷、調直、彎曲加工時,應按機械操作規程進行;每臺機械應有單獨的開關、保護、接零、接地等電氣設施,并且專機專人操作。
2、 直鋼筋,卡頭要卡緊,地錨要結實牢固,拉筋沿線2M區域內禁止行人。
3、 綁扎立柱、墻體鋼筋不得站在鋼筋架上,也不得攀登骨架上下;柱筋在4M以上時應搭設工作臺。
4、 起吊鋼筋或鋼筋骨架時,下方禁止站人;鋼筋或鋼筋骨架落到離樓地面1M以內時方準靠近、就位支撐好才能摘鉤;多人運鋼筋時,起、落、轉、停動作要一致,人工上下傳遞不得在同一垂直線上。
5、 搬運和安裝鋼筋時嚴防鋼筋碰觸電源;高空作業時,應嚴防鋼筋靠近高壓線路。
6、 在樓面臨時工時堆放鋼筋應考慮模板及支頂?shù)某休d力,不得過分集中;新澆砼樓面未凝固前,禁止堆放鋼筋。
7、 在高空安裝鋼筋應選好位置站穩、系好安全帶。
8、 焊機必須接地良好,不準在露天雨水的環境下工作。
鋼筋、工具等不應放置在外墻腳手架上,以免跌落傷人。
Security cards on the table contents:
1, were reinforced by mechanical cutting, straightening, bending, the mechanical operation procedures should be carried out; each machine should have a separate switch, protection, then zero, grounding and other electrical facilities, and operate hand plane.
2, straight bars, the first card to card tight, anchors should be strong, and stretching along the prohibited area 2M pedestrians.
3, lashing the column, not standing on the wall of reinforced steel shelves, nor skeleton climbing up and down; column should be reinforced in the erection of more than 4M table.
4, lifting steel or steel skeleton, the lower station were prohibited; steel or reinforced skeleton fell to the ground from the floor, within the time allowed to be close to 1M, in place to support good Hook; people transported reinforced when starting off, turn, action to stop the same, man must not pass up and down the same vertical line.
5, handling and installation of reinforced steel bar when the guard against the touch power; high-altitude operations, should guard against the bar near the high voltage line.
6, the floor should be considered temporary steel when stacked the top of the template and support capacity, not over-concentration; new pre-cast concrete floor hardening, prohibit stacking steel.
7, installation of reinforced high-altitude location shall be selected a firm, fasten your seat belts.
8, welder must be grounded well, are not allowed in the open water of the environment.
Steel, tools, etc. should not be placed in the external scaffold so as to avoid fall injuries.
