滑升模板安裝工程安全作業交底.doc

內容摘要：
1、 滑模平臺在提升前應對全部設備裝置進行檢查，調試妥善后方可使用，重點放在檢查平臺的裝配、節點，電氣及液壓系統。
2、 平臺內，外吊腳手架使用前，應一律安裝好輕質牢固的小眼安全網，并將安全網從外吊腳手架底部包到緊靠筒壁的吊腳手架里欄桿上，經驗收合格后方可使用。
3、 為了防止高空物體墜落傷人，筒身內底部，一般在2.5m高處搭設雙層保護棚，雙層間距不得小于600mm，并一上部宜鋪一層6-8mm鋼板防護，或5cm厚木板。
4、 避雷設備應有接地線裝置，平臺上振動器\電機等應接地或接零。
5、 通信設備除電鈴和信號燈外，還應裝備3-4臺步話機。
6、 滑升模板在施工前，技術部門必須做好切實可行的施工方案及流移示意，操作人員必須嚴格遵照執行。
7、 滑模在提升時必須統一指揮，并有專人負責測量千斤頂，平臺應保持水平，升高時出現不正常情況時，應立即停止滑升，再找出原因，并制定相應措施后方準繼續滑升。
8、 滑模施工設計時，必須注意施工過程中結構的穩定和安全。
9、 滑模施工工程操作人員的上下，應設置可靠樓梯或在建筑物內及時安裝樓梯。
10、用降模法施工現澆樓板時，各吊點應加設保險鋼絲繩。
11、滑模施工中，應嚴格按施工組織設計要求分散堆載，平臺不得超載且不應出現不均勻堆載的現象。
12、施工人員必須統一服從指揮，不得擅自操作液壓設備和機械設備。
13、滑模施工場地必須有足夠的照明，操作平臺上的照明采用36V的安全電壓。
14、凡患有高血壓、心臟病及醫生認
Abstract:
1, sliding platform to enhance the former should inspect all equipment installations, commissioning properly before use, focusing on the inspection platform assembly, node, electrical and hydraulic systems.
2, platform, internal and external use of suspended scaffolding, should be installed with small eyes light strong safety net, safety nets and scaffolding hanging from the outside bottom of the pack to close in cylinder wall hanging scaffold railing, and passes back may be used.
3, fall injuries in order to prevent high-altitude objects, Flashlight in the bottom, usually in the erection of 2.5m high roof double protection, double spacing of not less than 600mm, and an upper layer of 6-8mm appropriate protective plate, or wood 5cm thick board.
4, lightning protection equipment should be grounded wire device, platform vibrator \ motor and so should be grounded or connected zero.
5, communications equipment than bells and lights, the station should be equipped with walkie-talkies 3-4.
6, sliding template before construction, technology departments must do a practical construction plan and the current shift indicated, the operator must be strictly followed and implemented.
7, sliding must be unity of command in the upgrade and have the person responsible measure jack, the platform should remain level, when higher abnormal situation, should immediately stop sliding, and then find out the reason behind the standards and develop appropriate measures to sliding.
8, slipform construction design, construction process must pay attention to the structure's stability and security.
9, sliding up and down the construction project operator, should be set to secure the stairs or the installation of stairs in a building in a timely manner.
10, with reduced form construction of floor slab, each lifting point should be added an insurance rope.
11, sliding construction, should be strictly required by the construction organization design distributed loading, platforms may not overloaded and should not have uneven Loading phenomenon.
12, construction workers must be unity of command and obedience are not allowed to operate hydraulic equipment and machinery.
13, sliding construction site must have adequate lighting, the lighting on the platform with 36V safe voltage.
14, who suffers from high blood pressure, heart disease and doctors believe
 

前往下載