開關、插座安裝技術交底-北京建工集團.doc

 1  范圍
    本工藝標準適用于室內電氣照明的開關、插座安裝工程。
    2  施工準備
    2.1  材料要求：
    2.1.1  各型開關：規格型號必須符合設計要求，并有產品合格證。
    2.1.2  各型插座：規格型號必須符合設計要求，并有產品合格證。
    2.1.3  塑料（臺）板：應具有足夠的強度。塑料（臺）板應平整，無彎翹變形等現象，并有產品合格證。
    2.1.4  木制（臺）板：其厚度應符合設計要求和施工驗收規范的規定。其板面應平整，無劈裂和彎翹變形現象，油漆層完好無脫落。
    2.1.5  其他材料：金屬膨脹螺栓、塑料脹管、鍍鋅木螺絲、鍍鋅機螺絲、木磚等。
    2.2  主要機具：
    2.2.1  紅鉛筆、卷尺、水平尺、線墜、絕緣手套、工具袋。高凳等。
    2.2.2  手錘、鏨子、剝線錯、尖嘴鉗、扎錐、絲錐、套管、電鉆、電錘、鉆頭、射釘槍等。
    2.3  作業條件：
    2.3.1  各種管路、盒子已經敷設完畢。盒子收口平整。
    2.3.2  線路的導線已穿完，并已做完絕緣搖測。
1 Scope
    This technology is applicable to indoor electrical lighting switches, socket installation.
    2 construction preparation
    2.1 Material Requirements:
    2.1.1 The various types of switches: Model specifications must meet the design requirements, and have a product certificate.
    2.1.2 The various types of outlet: Model specifications must meet the design requirements, and have a product certificate.
    2.1.3 Plastics (Taiwan) board: should have sufficient strength. Plastic (Taiwan) board should be flat, no warping deformation phenomena, and have product certification.
    2.1.4 Wooden (Taiwan) plate: its thickness should be consistent with design requirements and construction requirements for acceptance. The board should be flat, no deformation of splitting and warping, paint peeling off layers intact.
    2.1.5 Other materials: metal expansion bolts, plastic expanded tube, galvanized wood screws, galvanized machine screws, wooden bricks.
    2.2 Main equipment:
    2.2.1 red pencil, tape measure, spirit level, line sinkers, insulated gloves, tool bags. High stool so.
    2.2.2 hand hammer, chisel, stripping wrong, needle-nosed pliers, bar-cone, tap, casing, drill, hammer, drill, nail gun, etc..
    2.3 Operating conditions:
    2.3.1 all kinds of pipe, the box has finished laying. Shut the box formation.
    2.3.2 has been wearing complete line of wire and insulation has been done shake test.
 

前往下載