室內電氣安裝常見缺陷的防治.doc
進入下載頁
室內電氣安裝常見缺陷的防治
室內電氣安裝工程中，經常因?yàn)橐恍┤毕荻绊懯┕べ|(zhì)量，因此，對該類缺陷的預防處理，就顯得尤為重要。
一、塑料管線敷設
1、常見缺陷
接口不嚴密，有漏水、滲水現象；現澆板內配管時出現管、盒內漏漿、堵塞，造成剔鑿混凝土的后果；煨彎處出現扁、凹、裂等。
2、缺陷原因
接口處滲水是因?yàn)榻涌谔幬醇犹祝还芑虺胁蹇谧龅锰�，又未涂粘結劑，只用黑膠布或塑料帶包纏，而未按規程施工。PVC管煨彎時未加熱或加熱不均勻，造成管路扁、凹、裂現象。
3、預防處理
Interior electrical installation Defects Prevention
Interior electrical installation works, often because of some defects at the construction quality, therefore, that type of defect prevention treatment, it is very important.
A plastic pipe laying
A common defect
Interface is not tight, there is leakage of water leakage; place when piping plate pipe, box mud leakage, blockage, causing tick chisel concrete consequences; simmer bend occurring at the flat, concave, split and so on.
2, Defects
Interfaces because the interface of water seepage is not jacketed; tube or bearing jack too short, it is not coated adhesive, only with black tape or plastic wrapped, but fails to order construction. PVC pipe and far corner without heating or uneven heating, resulting in pipeline flat, concave, crack phenomenon.
3, Prevention Treatment