塑料護套線配線技術交底-北京建工集團.doc

  1  范圍
    本工藝標準適用于室內電氣照明的塑料護套線明配線工程。
    2  施工準備
    2.1  材料要求：
    2.1.1  塑料護套線：導線的規格、型號必須符合設計要求，并有出廠合格證。
    2.1.2  螺旋接線鈕：應根據導線截面和導線的根數選擇相應型號的加強型絕緣鋼殼螺旋接線鈕。
    2.1.3  LC安全型壓線帽有關要求見3?、2.1.5條有關內容。
    2.1.4  套管：套管有銅套管、鋁套管及銅鋁過渡套管三種，選用時應采用與導線材質規格相應的套管。
    2.1.5  接線端子（俗稱接線鼻子）：選用時應根據導線的根數和總截面選擇相應規格的接線端子。
    2.1.6輔助材料：鍍鋅木螺絲、焊錫、焊劑、木磚、釘子、
1 Scope
    This technology is applicable to indoor electrical lighting wiring works out plastic sheathing line.
    2 construction preparation
    2.1 Material Requirements:
    2.1.1 plastic sheath line: conductor size, type must meet the design requirements, and have factory certification.
    2.1.2 Spiral Connection button: wire cross section and the conductor should be based on the root of the number of select models of reinforced steel spiral wire insulation button.
    2.1.3 LC-type pressure line safety cap requirements, see 3?, 2.1.5 the content.
    2.1.4 casing: casing with copper pipe, aluminum, copper and aluminum casing, and the transition sleeve of three, and wire material used should be standard with the appropriate casing.
    2.1.5 Terminal (commonly known as wire nose): Selection shall be based on the root number and total wire cross section select the appropriate size of the terminal blocks.
    2.1.6 Auxiliary materials: galvanized wood screws, solder, flux, wood blocks, nails,
 

前往下載