塑料線槽配線技術交底-北京建工集團.doc

  1  范圍
    本工藝標準適用于干燥室內的電氣照明明配線工程。
    2  施工準備
    2.1  材料要求：
    2.1.1  塑料線槽：由槽底、槽蓋及附件組成，它是由難燃型硬聚氯乙烯工程塑料擠壓成型，嚴禁使用非難燃型材料加工。選用塑料線槽時，應根據設計要求選擇型號、規格相應的定型產品。其敷設場所的環境溫度不得低于-15℃，其氧指數不應低于27%。以上線槽內外應光滑無棱刺，不應有扭曲、翹邊等變形現象。并有產品合格證。
    2.1.2  絕緣導線：導線的型號、規格必須符合設計要求，線槽內敷設導線的線芯最小允許截面：銅導線為1.0mm2；鋁導線為2.5mm2。
    2.1.3  螺旋接線鈕：應根據導線截面和導線根數，選擇相應型號的加強型絕緣鋼殼螺旋接線鈕。
    2.1.4   LC安全型壓線帽請見3.2.1.5有關內容。
1 Scope
    This technology is applicable to drying chamber according to the electrical wiring works obviously.
    2 construction preparation
    2.1 Material Requirements:
    2.1.1 Plastic trough: the bottom of the tank, tank cover and annexes, it is a flame-type PVC plastic extrusion, forbidden to use non-flame retardant type material processing. Use plastic trunking should be selected according to design type, the appropriate setting product specifications. The installation site ambient temperature of not lower than -15 ℃, the oxygen index of not less than 27%. Groove above the inner and outer edges smooth without thorns, should not be distorted, such as deformation of Alice side. And a product certification.
    2.1.2 Insulated wire: wire models, specifications must meet the design requirements, groove laying wire line core within the minimum allowable section: copper wire is 1.0mm2; aluminum wire is 2.5mm2.
    2.1.3 Spiral Connection button: wire cross section and the conductor should be based on root number, select the appropriate type of reinforced steel spiral wire insulation button.
    2.1.4 LC-safe pressure line caps, see 3.2.1.5 the content.
 

前往下載