普通燈具安裝工藝標準.doc

普通燈具安裝工藝標準
    總則、術語符號及基本規定參見5不間斷電源安裝。
    11．1  施工準備
    11．1．1  技術準備
    (1) 施工前應進行技術交底工作；
    (2) 配備相應的施工質量驗收規范。
    11．1．2  材料設備要求
    (1) 注意核對燈具的標稱型號等參數是否符合要求，并應有產品合格證，普通燈具有安全認證標志。
    (2) 照明燈具使用的導線其電壓等級不應低于交流500V，其最小線芯截面應符合規定。
    (3) 采用鋼管作為燈具的吊管時，鋼管內徑一般不小于10mm。
    (4) 花燈的吊鉤其圓鋼直徑不小于吊掛銷釘?shù)闹?br /> General lighting standard installation process
    General principles, terminology and basic provisions of symbols see 5 uninterruptible power supply installation.
    11.1 Construction preparation
    11.1.1 Technical Preparation
    (1) the classification of components should be carried out before construction work;
    (2) with the corresponding acceptance of construction quality.
    11.1.2 The material and equipment requirements
    (1) Note that the nominal model matching parameters such as lighting for compliance and should have product certification, general lighting a safety certification mark.
    (2) lighting wire the voltage levels used in exchange should not be less than 500V, the minimum wire core section shall comply with requirements.
    (3) using steel as a hanging lamp tube, steel pipe inner diameter is generally not less than 10mm.
    (4) lantern hook the round bar diameter is not less than hanging straight pin
 

前往下載